The service life of the double-layer glass reactor is not only related to the inverter, glass and motor, but also closely related to daily maintenance. To extend the service life of the double-layer stirred glass reactor and maintain your interests, please carefully Read this section, the double-layer glass reactor sandwich can provide high temperature reaction (higher temperature can reach 300 ° C), can also do low temperature reaction (lower temperature can reach -80 ° C); and these daily work on double glass reaction The kettle damage is very large, so daily maintenance is very important.

 

S-50L Double layer glass reactor

1. Check whether the interfaces of the instrument are consistent. Pay attention to it.

2. The interfaces should not be tightened too tightly. It should be loosened regularly to avoid the long-term tight lock and cause the connector to die.

3. Wipe each interface with a soft cloth (can be replaced with a napkin) and apply a small amount of vacuum grease. (The vacuum grease must be covered after use to prevent the entry of lime sand.

4. Regularly clean the sealing ring by removing the sealing ring and checking if there is dirt on the shaft. Wipe it with a soft cloth, then apply a little vacuum grease and reinstall it to keep the shaft and seal ring smooth.

5. the PTFE switch everywhere can not be tightened too much, easy to damage the glass.

6. Loosen the PTFE switches after stopping, and the PTFE piston will be deformed when it is still working for a long time.

7. Turn on the power switch first, then let the machine run from slow to fast. When the machine stops, stop the machine and turn off the switch.

8. Every time you use it, you must use a soft cloth to clean all kinds of oil traces left on the surface of the machine, stains, solvent remaining, and keep it clean.

9. the electrical part must not enter the water, it is strictly prohibited to get wet.
10. must purchase the original authentic accessories, free use of other accessories can cause fatal damage to the machine.