Rules for using stainless steel reactor
The stainless steel reactor kettle will definitely cause harm to the human body during the high temperature cycle reaction. In order to reduce the damage to the human body, when the stainless steel reaction kettle is performing the high temperature reaction, the circulation pump must be turned on first, so that The equipment slowly heats up during the heat conduction cycle, which is harmless to the equipment and of course, the harm to people will be small.
Before feeding, check its equipment for contamination. Effectively clean the inner wall, stirring and joint surfaces of the autoclave with ethanol, then rinse with distilled water. After washing, wipe with cotton or silk cloth dipped in ethanol To prevent cross-contamination of materials.
Before use, check whether each valve is unblocked, especially the pressure gauge and explosion-proof film nozzle. For the inlet duct, special attention must be paid to the clogging phenomenon. If the stainless steel reactor is used, if the material is contaminated or blocked, the duct and the inlet branch pipe should be removed from the lid of the kettle, cleaned and then installed.
What should be paid attention to when using stainless steel reactor
1. During the operation of the stainless steel reactor, the refrigerant inlet valve must be closed to effectively drain the remaining refrigerant in the pot and jacket, and then input the materials. Start the stirrer, then open the steam valve and the electric heating power supply. When the required temperature is reached, the steam valve and the electric heating power supply should be closed first, and then the stirrer should be closed after 2 to 3 minutes.
2. When there is no material in the pot, do not open the steam valve and electric heating power. Pay special attention to the use of steam pressure, which must not exceed the rated working pressure.
3. After the processing is completed, after the remaining condensed water in the pot and the jacket is effectively drained, it should be rinsed with warm water as soon as possible, brush out the sticky materials, and then thoroughly wash the inner wall of the container with alkaline water at 40 ° C to 50 ° C.
4. In the process of use, it is necessary to close its refrigerant inlet valve, and to a certain extent, exhaust the remaining refrigerant in the pot and the jacket. Then enter the material. What do you need to pay attention to?